Reasons for Dry, Withered Leaves on the Echeveria pulidonis Succulent, Solutions, and Propagation Tips
The Echeveria pulidonis succulent is one that many people love to grow. Its leaves are usually red and green, very beautiful. But many people run into problems when growing it, and the most common one is dry, withered leaves. Actually, there are plenty of tricks to solve these problems too.
Reasons for Dry, Withered Leaves on the Echeveria pulidonis Succulent
When Echeveria pulidonis leaves wither, it is usually caused by watering. Most people do not pay attention when watering, pouring from the top all the way down, so that water collects where the leaves meet the stem. Over time the water goes bad and causes the joint to rot, and the leaves wither as well.
Solutions for Dry, Withered Leaves on the Echeveria pulidonis Succulent
1. Succulents shriveling during normal metabolism mostly happens on old plants, showing as slight shriveling of the lower leaves. This is actually very normal, and you just need to let nature take its course.
2. After Echeveria pulidonis leaves wither, remove the withered and rotten leaves, and apply carbendazim to the rotten wound, or apply erythromycin eye ointment to the wound, to prevent reinfection by bacteria.
3. In addition, we should also check whether there are pests and diseases. If pests or diseases are found, deal with them promptly and pick off the affected leaves. Specifically, check the roots first, then the leaves, and treat the cause accordingly.
Echeveria pulidonis Propagation Methods
1. Beheading. Beheading and cutting succulents is generally done in spring and autumn, as these two seasons are the growing season for succulents. Echeveria pulidonis is best leaf-propagated in spring, not only because the success rate is highest, but also because this season makes it easiest to grow healthy and beautiful little succulent pups. In a ventilated, bright spot with indirect light, pups will grow, and then gradually increase the light. Echeveria pulidonis beheading and cutting tips: because Echeveria pulidonis has a tight rosette, finding the spot to cut is not easy, so you need to first pull off one or two leaves from the middle layer to leave room for the cut. Use a U-shaped carving knife to behead the Echeveria pulidonis, keeping the cut-off top in intact form, suitable for cutting. If the leaves on the cut-off top happen to fall off, you can also propagate them by leaf, so there is no need to worry. Echeveria pulidonis beheading and cutting care: after beheading the Echeveria pulidonis, apply carbendazim to the wound to prevent pests and diseases. Place it in a ventilated, shady spot to prevent the wound from rotting. After beheading the Echeveria pulidonis, when it grows small shoots, it will consume the lower leaves of the original plant, so there is no need to worry.
2. Echeveria pulidonis can also be propagated by leaf cuttings, but leaf cuttings are a bit slow. Take off complete, mature leaves, put them in a shady spot to let the wounds dry, then place them on soil. The soil should not be too wet, just slightly moist, and it will slowly sprout and grow into a new plant.
Echeveria pulidonis Winter and Summer Care Tips
1. Under low winter temperatures and full sun, the leaf tips and leaf edges easily turn red, very charming. In the past there was also a name for it, red-edged stone lotus. With the leaf edges tinged red, it is gorgeously beautiful like a beauty wearing a qipao, especially alluring. Echeveria pulidonis is a summer-growing type of succulent. It goes dormant in winter. For winter care, the temperature should not be lower than 5 degrees, and water must be withheld in winter to prevent frost damage and rot.
2. In late spring and early summer, Echeveria pulidonis will bloom with yellow flowers, with five petals, like little bells. If the flowering period shifts later, you need to get the Echeveria pulidonis safely through the summer, because the flowering period has a relatively high nutrient demand. You can fertilize appropriately. In summer, high temperatures are common nationwide. When the summer temperature is above 30 degrees, water must be withheld. During the water-withholding period, the leaves will become wrinkled, which is purely normal. Once the temperature rises and you water, it will recover its lively appearance.
Echeveria pulidonis leaves drying out is generally caused by overwatering. If this happens, you can apply some medicine to the wound site to prevent infection. When caring for Echeveria pulidonis, you need to understand its habits. Care in spring and summer is different, so everyone should learn more about its care methods.